⒈ Select Flat table, put the machine, you can open the chassis to make the machine panel easy to observe.

⒉ the plug on the handheld sensor head into the socket on the panel and tighten it. Attention to location gaps ·

⒊ plug one end of the power cord into the socket on the back panel of the chassis and plug the other end into the power supply socket, make sure to use single-phase three-wire power supply.

⒋ Open the "power SW." On the rear panel of the chassis, press the POWER switch (switching) button on the panel, and the machine will work when the "Ready (WARM up)" Green indicator light is on.

⒌ Press the "Set button" key, set to the appropriate value, typically between 0.5-2 seconds.

⒍ the sensor head on the lid of the container, click on the Start button on the handle, when the "heating (heating)" Red indicator light, said is heating, induction head do not move, "heating (heating)" Red led out and then remove the sensor head, and so on "ready (WARM up)" Green indicator light or in-machine buzzer short sound "beep" prompts can also carry out the next container sealing operations.

⒎ Check the sealing quality, according to different materials, diameter of the container and production efficiency, appropriate trimming "set button (SETTING button) key to make the best sealing quality."